new banner.jpg (9737 bytes)


Farmi Winch

Farmi Tractor Winch

Farmi Logging Winch for Skid Steer Loaders

Skidding Accessories

The Farmi Tree Harvesting Method

Features of the Farmi Winches

Spare Parts Lists for Farmi Winches

Valby Woodchippers

Back to Homepage



Farmi JL 351PHD

Skid Steer Winch

The Farmi JL351PHD winch hooks up to the universal type quick tatch skid steer plates. The winch is powered by oil flow from the skid steer. The winch is supplied with hoses which hook up to the skid steer. The hoses have pipe thread and do not have quick couplers to match the quick couplers on the skid steer. (Too many different standards out there.) The operator operates the winch not from the skid steer loader’s seat but from a safe position on the side of the winch. The winch has two control ropes. One rope controls the pulling and the other controls the drum brake. The operator can stand safely to the side, away from the cable and the logs. The operator engages the clutch by pulling the control rope.  The harder one pulls on the rope, the more the winch pulls.  One can start and stop the pull at any time. The clutch control rope runs through a swivel on top of the winch. The winch can therefore be operated from any direction. This is an important feature for the operator as he can move to either side and control the winch from a position from where he can see the load as he is pulling it in. The clutch enables the operator to select any pull from zero to maximum pull of the winch. The clutch will slip when the load is heavier than the selected pull.  This prevents damage to the cable or winch even if the load gets hooked behind a stump or root.

The clutch has a 5 year warranty.

A new clutch can be riveted on the on the old sprocket so the clutch is easy and inexpensive to replace. The massive upper sprocket acts as a heat sink and absorbs the heat which is generated in the clutch when winching, so the clutch will not burn out.

The winch frame is high. The high point of pull is very beneficial, because it generates down-pressure on the winch when winching. The down-pressure pushes the blade into the ground which anchors the winch and skid steer in place. Four trees can be winched in one hitch. After the trees are winched in, one can pull them around by slipping the cable under the lower snatchblock.

Clutch adjustment, brake adjustment, replacing the cable and all other service can be done without any disassembly of the winch. Repair of the winch is also very easy because the entire winch mechanism can be removed in one piece after removal of six (easy to get to) bolts.

The winch has a built in dozerblade. The blade can be used to stack logs on the landing, open trails, clear snow.

wpe37.jpg (64465 bytes)



  • Pulling capacity 7720 lbs
  • Drum capacity: 180 feet of 3/8" cable
  • Winching speed: 40-200 feet per minute.
  • Clutch: Mechanical friction plate clutch with heat sink.
  • Oil flow required: 15 gpm @ 2000 psi
  • Mounting: To skid steer loader quick attachment plate.
  • The winches are sold complete with 165' of 3/8" steel core wire rope.
  • Height with screen: 77 "
  • Width: 48"
  • Shipping weight: 750 lbs.


Click here for features unique to the Farmi winches

Click here for time saving accessories for the Farmi winches


Send mail to with questions regarding our products, or call (607) 589-6160.  Fax: (607) 589-4026.   Mail:  PO Box 15, Spencer NY 14883